Adder Technology AdderView CATx EPS-S8 - Manual (Page 53)















To select a computer using hotkeys
1. Simultaneously.press.and.hold.
.and. .
Note: The and keys when pressed in combination are called
‘hotkeys’ and they signal to the AdderView CATx that you wish to control
it, rather than the computer. However, if these particular hotkeys clash with
another device or program, then your administrator may change them to a
different combination. If the
combination fails to work, then please
contact the system administrator for details.
2. While.still.holding. .and. ,.press.the.first.numeral.of.the.required.port.
address,.then:.
•. If.the.port.address.is.a.single.character,.release.all.of.the.keys.
•. If.the.port.address.is.two.or.more.characters,.release.the.first.numeral.
key.and.press.the.second.–.repeat.this.procedure.until.all.of.the.port.
address.numerals.have.been.entered,.then.release.
.and. ...
Note: The numbers on your keyboard’s numeric keypad are not valid, use
only the numeral keys above the QWERTY section.
Note: If your user port does not have authorisation to view the selected port
then an ‘Insufficient user rights’ messages will be displayed.
Standard hotkeys
The.range.of.hotkey.combinations.are.as.follows:
Note: If your hotkeys have been changed, substitute them for
and in
the examples given here.
. . . Selects.port.1
. . . Selects.port.2
•. •
•. •
. . .then. . Selects.port.10
•. •
. . .then. . Selects.port.24
. Note: When entering multiple digit addresses as
above or for even longer cascaded computers,
keep
and pressed down until all other
numbers have been entered.
. . . Selects.the.next.available.port
. . . Selects.autoscan.mode.where.each.(authorised).
port.is.displayed.for.a.period.determined.by.
the.administrator..To.cancel.autoscan.mode,.
simply.select.any.fixed.channel.using.any.of.the.
suggested.methods.
. . . Switches.off.the.video.signal.–.this.will.cause.
a.power.saving.monitor.to.enter.its.standby.
mode..To.awaken.the.monitor,.simply.select.
any.fixed.channel.using.any.of.the.suggested.
methods.
. . . Logs.out.the.current.user.(if.security.is.enabled).
or.selects.port.0.to.disable.the.video.signal.(if.
security.is.disabled).
. .&. ,. ,. .or. .. Moves.the.currently.displayed.on-screen.menu.
around.the.screen..