Asus II/CELERON P2V - Manual (Page 31)

ASUS P2V User’s Manual 31
III. INSTALLATION
Connectors
III. INST
ALLA
TION
13. Wake-on-LAN Connector (3-pin WOL_CON)
The WOL_CON connector powers up the system when a wakeup packet or
signal is received from the network through the ASUS PCI-L101 LAN card (see
section VII. ASUS LAN Card).
IMPORTANT: This feature requires that the WAKE On LAN Power Up Control is
set to Enabled (see “Power Management Setup” under IV. BIOS SOFTWARE) and
that your system has an ATX power supply with at least 720mA +5V standby power.
IMPORTANT: Requires an ATX power
supply with at least 720mA +5 volt
standby power
Wake-on-LAN Connector
+5 Volt Standby
(No Connection)
Ground
R
14. SMBus Connector (5-1 pin SMB)
This connector allows you to connect SMBus devices. SMBus devices commu-
nicate by means of the SMBus with an SMBus host and/or other SMBus de-
vices. The SMBus or System Management Bus is a specific implementation of
an I
2 C bus, which is a multi-master bus, that is, multiple chips can be connected
to the same bus and each one can act as a master by initiating data transfer.
P2V SMBus Connector
R
SMBCLK
Ground
SMBDATA
+5V
1