Asus DVD-R/RW Drive DVR-104 - Manual (Page 15)

ASUS DVR-104 User’s Manual 15
Setting the Jumper Terminals
Configure the jumpers to set the device to master or slave mode before
physically installing it to your computer chassis. Use jumper blocks to short
the pins to your desired setting.
Make sure to correctly put the jumper blocks over the pins.
Failure to do so may cause irreparable damage to the drive!
Master Mode
Cover the two pins labeled MA (see illustration) to set
the DVD-R/RW drive as a secondary master drive.
This is possible only if your computer supports four
IDE devices. The hard disk in the computer is set as
Primary Master.
Slave Mode
Cover the two pins labeled SL (see illustration) to
set the DVD-R/RW drive as a slave device if your
computer supports only two IDE devices.
If your computer supports four IDE devices, this
setting sets your DVD-R/RW drive either as a
Primary Slave or a Secondary Slave.
Cable Select Mode
Cover the two pins labeled CS (see illustration) if your
computer supports a Cable Select (CSEL) signal. You
need an exclusive interface cable for this setting.
Refer to your computer manual for details.
JUMPER
TERMINALS
RESERVED PIN 1
RESERVED PIN 1
RESERVED PIN 1
MA
SL
CS
+DVR-104 (09-24).P65 6/20/02, 3:13 PM 15