Sony VPL-VW1100ES User Manual

Page 49

Turn on the unit, then select the

desired setting item on the Setup

menu.

The menu screen below will be
appeared.

Select “Yes.”

Do not put your hands into the lamp
replacement slot, and do not allow any liquid or
other objects into the slot to avoid electrical
shock or fire.

• Be sure to use an LMP-H330 Projector Lamp

for replacement. If you use lamps other than
the LMP-H330, the unit may malfunction.

• Be sure to turn off the unit and unplug the

power cord before replacing the lamp, then
check the ON/STANDBY indicator has
already been turned off.

• The unit will not turn on unless the lamp is

securely installed in place.

• The unit will not turn on unless the lamp

cover are securely closed.

• To cancel a message displayed on the screen,

press either the button on the remote control
or the one on the control panel on the unit.

Note on replacing the lamp when
broken, in the case of a ceiling
installation
If the lamp breaks, broken lamp pieces may
scatter and cause injury.
When the unit is on the ceiling, remove the
lamp door (inner cover) by sliding it
horizontally slowly after raising it with 30
degree opened. Avoid twisting the lamp door
(inner cover).

Disposal of the used lamp

For the customers in the USA
Lamp in this product contains mercury.
Disposal of these materials may be
regulated due to environmental
considerations. For disposal or
recycling information, please contact
your local authorities or the
Telecommunications Industry
Association (www.eiae.org).

Caution

Notes

Note
The lamp contains mercury. The disposal
rules for used fluorescent tubes depend on
where you live. Follow the waste disposal
policy in your area.

30°