Alpine DVA-9861Ri - Manual (Page 64)

63
-EN
01GB06DVA9861Ri.fm
ALPINE DVA-9861Ri 68-04123Z62-A (EN)
Installation
Accessory List
• Head unit .............................................................................1
• Power cable.........................................................................1
• FULL SPEED™ Connection Cable ......................................1
• Mounting sleeve ..................................................................1
• Carrying case ......................................................................1
• Rubber Cap .........................................................................1
• Hex Bolt ...............................................................................1
• Screw (M5x8).......................................................................4
• RCA extension cable (Video) (2m) ......................................1
• Remote control ....................................................................1
• Battery (CR2025) .................................................................1
• Owner’s Manual .............................................................1 set
• The main unit must be mounted within 35 degrees of the horizontal
plane, back to front.
Caution
Do not block the unit’s fan or heat sink, thus preventing air
circulation. If blocked, heat will accumulate inside the unit and
may cause a fire.
1
Slide mounting sleeve from main unit (see
“Removal” on page 64). Slide the mounting sleeve
into the dashboard and fix it with the metal shackles.
Air ventilation hole
(Rear side)
Less than 35°
Bracket
Rubber Cap
(Included)
Hex Bolt
(Included)
this unit
Dashboard
Mounting sleeve
(Included)
2
When your vehicle has the Bracket, mount the long
hex bolt onto the rear panel of the DVA-9861Ri and
put the Rubber Cap on the hex bolt. If your vehicle
does not have the Mounting Support, reinforce the
head unit with the metal mounting strap (not
supplied). Connect all the leads of the DVA-9861Ri
according to details described in the “Connections”
section.
• For the screw*, provide a proper screw to the chassis installing
location.
3
Slide the DVA-9861Ri into the dashboard. When the
unit is in place, make sure the locking pin is fully
seated in the down position. This can be done by
pressing firmly in on the unit while pushing the
locking pin down with a small screwdriver. This
ensures that the unit is properly locked and will not
accidentally come out from the dashboard. Install
the Detachable Front Panel.
∗
Metal Mounting Strap
Screw
this unit
Bolt Stud
Hex Nut (M5)
Lock pin
01GB00DVA9861Ri.book Page 63 Wednesday, December 7, 2005 12:00 PM