Alpine CVA-1004 - Manual (Page 40)

38
-EN
Other Useful Features
→ External CD → External DVD
Changer
← DVD changer ←
Switching Disc Mode
Use this function when connecting the optional
CD/DVD player, changer.
1
Press BAND/TEL. to switch the Disc mode in the
CD/DVD changer mode.
Example
Operating an External Audio
Processor (Optional)
You can operate a connected external audio
processor from the CVA-1004.
1
When an external audio processor is connected,
press bass engine to activate Audio Processor
mode.
2
Press a preset button (1 through 3) to select
the desired function, and then g or f to
adjust settings.
When the ERA-G310/ERA-G320/CDA-5755/
PRA-H600/PXA-H510/PXA-H900 is connected
preset 2: Subwoofer phase control
(NORMAL/REVERSE)
∗
1
preset 3: Recalling the stored settings
(Preset 1 through 6)
∗
2
When the PXA-H400 is connected
preset 1: Bass/Treble control (-7 ~ +7)
preset 3: Recalling the stored settings
(Preset 1 through 4)
When the PXA-H700 is connected
preset 1: Setting the MX mode
(MX compatible sources only)
preset 2: Subwoofer phase control
(NORMAL/REVERSE)
∗
1
∗
1 When the monitor is open: displayed in the monitor
0°
↔ 180°
When the monitor is closed: displayed in the sub-display
NOR
↔ REV
∗
2 When the CDA-5755 is connected: (Preset 1 through 4)
3
Press bass engine to return to normal mode.
NOTE
For details about external audio processor operation, see
the owner’s manual of the external audio processor.
Displaying Spectrum Analyzer
When using the optional expansion box (KCE-
104V), you can use this function.
After carrying out steps 1 to 3 of “To display the
SETUP screen” (page 29), perform the operation
shown below.
1
When the monitor is open, press and hold
MUTE/SETUP for at least 2 seconds. The
SETUP screen appears.
2
Press preset 5 to activate the SYSTEM setting
mode. Press preset 5 again to select SPE.ANA.
3
Press g or f to select ON or OFF.
Set to ON, then press V.SEL to select the
Spectrum Analyzer display (refer to
“Simultaneous Operation” on page 39).
For any other settings, press preset 5 or another
preset button.
4
After setting is completed, press MUTE/SETUP
to return to normal mode.
NOTE
When an external Audio Processor is connected,
Spectrum Analyzer is displayed only in AM or FM mode.
bass engine
V.SEL BAND/
TEL.
Preset buttons
(1through 3)
f g Preset 5
SOURCE/PWR
TITLE
MUTE/
SETUP