Sony PCV-RS310 - Manual (Page 58)

VAIO Computer System Reference Manual 44
8 Slide the new drive into the drive holder and align the holes on each
side of the drive to the holes in the drive holder.
9
Secure the drive to the drive holder with screws, through the holes on
each side of the drive holder.
10
Realign the drive holder with the tracks on the inside of the chassis
and slide the drive holder in completely.
11 Reinsert the drive holder screw and tighten to lock the drive holder
back into position.
12
Connect the second drive connector to the new drive. Orient the
connector to align pin 1 on the red side of the ribbon cable with pin 1
on the new drive.
13
Connect the second power connector to the new drive, following the
instructions supplied with the drive.
Attaching the drive screws
✍
Your new hard disk drive is supplied with the necessary screws. Do not overtighten these
screws when securing the new drive to the drive holder.