Sony STR-DG600 - Manual (Page 84)

84 US
C:\Documents and
Settings\pc13\Desktop\JC060000_2662260114DG600_US\2662260116\US08REM_STR-DG600-
U.fm masterpage: Left
STR-DG600
2-662-260-11 (6)
If you are unable to remedy the
problem using the
troubleshooting guide
Clearing the receiver’s memory may remedy
the problem (page 30). However, note that all
memorized settings will be reset to their
factory settings and you will have to readjust
all settings on the receiver.
If the problem persist
Consult your nearest Sony dealer. Note that if
service personnel changes some parts during
repair, these parts may be retained.
Reference sections for clearing
the receiver’s memory
Specifications
AUDIO POWER
SPECIFICATIONS
POWER OUTPUT AND TOTAL
HARMONIC DISTORTION:
(Models of area code U only)
With 8 ohm loads, both channels driven, from
20 – 20,000 Hz; rated 100 watts per channel
minimum RMS power, with no more than
0.09% total harmonic distortion from 250
milliwatts to rated output.
Amplifier section
Models of area code U, CA
Stereo Power Output
1)
, Reference Power
Output
1)2)
8 ohms 20 Hz – 20 kHz, THD 0.09%
100 W + 100 W, 110 W/ch
8 ohms 1 kHz, THD 0.7%
110 W + 110 W, 120 W/ch
8 ohms 1 kHz, THD 10%
125 W + 125 W, 150 W/ch
1)
Measured under the following conditions:
2)
Reference power output for front, center, surround
and surround back. Depending on the sound field
settings and the source, there may be no sound
output.
To clear See
All memorized settings page 30
Customized sound fields page 60
Area code Power requirements
U, CA 120 V AC, 60 Hz
US01COV_STR-DG600-U.book Page 84 Thursday, March 16, 2006 11:32 AM