Sony BDV-E2100 - Manual (Page 41)

41 US
BDV-E6100/BDV-E4100/BDV-E3100/BDV-E2100
4-446-733-12(1)
D:\NORM'S JOB\SONY HA\SO130060\BDV-E6100_4100_3100_E2100
(PMRF 06)\4446733121_US (U2)\080OTH.fm masterpage: Right
Oth
e
r Op
eratio
ns
2
Press B/b to select [Setup].
3
Press V/v to select [Audio
Settings], then press .
4
Press V/v to select [Speaker
Settings], then press .
The [Select speaker layout.] display
appears.
5
Press V/v to select setting
according to your speakers
placement, then press
.
• [Standard]: The surround speakers
are installed in the rear position.
• [All Front]: All speakers are installed
in the front position.
The [Distance] and [Level] settings are reset
to default settings each time you change the
speaker layout setting.
6
Press V/v to select the item, then
press .
7
Press V/v to adjust the
parameter.
8
Press B/b and to confirm the
settings.
Check the following settings.
x [Distance]
Be sure to set the parameters of the distance
from the listening position to the speakers.
You can set the parameters from 0 to
23 feet (0.0 to 7.0 meters).
[Front Left/Right] 10 ft/3.0 m: Set the front
speaker distance.
[Center] 10 ft/3.0 m: Set the center speaker
distance.
[Surround Left/Right] 10 ft/3.0 m: Set the
surround speaker distance.
[Subwoofer] 10 ft/3.0 m: Set the subwoofer
distance.
You can change the unit of measurement (feet or
meters) by pressing the color button (RED).
x [Level]
You can adjust the sound level of the
speakers. You can set the parameters from
–6.0 dB to +6.0 dB. Be sure to set [Test
Tone] to [On] for easy adjustment.
[Front Left/Right] 0.0 dB: Set the front
speaker level.
[Center] 0.0 dB: Set the center speaker
level.
[Surround Left/Right] 0.0 dB: Set the
surround speaker level.
[Subwoofer] 0.0 dB: Set the subwoofer
level.
x [Test Tone]
The speakers will emit a test tone to adjust
[Level].
[Off]: The test tone is not emitted from the
speakers.
[On]: The test tone is emitted from each
speaker in sequence while adjusting level.
When you select one of the [Speaker
Settings] items, the test tone is emitted
from each speaker in sequence.
Adjust the sound level as follows.
1 Set [Test Tone] to [On].
2 Press V/v to select [Level], then
press .
3 Press V/v to select the speaker type
you want, then press .
4 Press B/b to select the left or right
speaker, then press V/v to adjust the
level.
5 Press .
6 Repeat Steps 3 to 5.
Note
Tip