Testing the scanner and the connection – AGFA DuoScan f40 User Manual
Page 17
Chapter 2: Installing the Scanner
17
Testing the Scanner and the Connection
You are now ready to check if the scanner is operating properly and if the devices are correctly
connected to your Macintosh.
1
Verify if the USB or FireWire cable is properly connected to your Macintosh.
2
Switch on your Macintosh.
As it starts up, your Macintosh performs a series of tests to verify the correct system
configuration.
3
Open the Scanner ID checker application and select the desired interface (USB or FireWire).
4
Verify if your scanner is visible.
"
Note: For more information, refer to the Scanner ID checker section in
.