ATTO Technology 1500D/E - Manual (Page 19)

10
Installation: ATTO iPBridge 1550D
Exhibit 1.4-1 iPBridge 1550D back panel
Installation instructions
1 Place the iPBridge 1550D where you want it.
2 Connect SCSI devices to the iPBridge. (See
Connecting SCSI devices to the SCSI port on
page 11)
3 Connect the iPBridge to your SAN: attach CAT
6 or CAT 5E cables to the Ethernet port on the
iPBridge or connect an RJ11 and adapter
crossover serial cable (null modem) between
the iPBridge serial port and one of the
computer's serial COM ports.
4 Connect the power connector and power up.
5 Boot the computers on the SAN.
6 Access iPBridge Services via the Ethernet port.
(See
Configuring the iPBridge on page 13) or
the serial port ( Connecting using the serial port
on page 14)
7 Verify that the bridge can be accessed on the
local Ethernet network by using the
Ping utility.
(See Step 7 on page 15)
8 Set up the configuration for the devices
connected to the iPBridge (See
Managing the
iPBridge on page 17.)
9 Power cycle the iPBridge. The iPBridge will
automatically map the devices on startup.
air vents
power
connector
Power
LED
SCSI port
activity LED
Ethernet
speed LED
Ethernet
activity LED