AEG LAVATHERM 56609 - Manual (Page 28)

Troubleshooting
28
Replace the filament bulb
0 Procure a special filament bulb for your Lavatherm through the
customer service organisation (ET-No. 647072580).
1 Warning! Never use standard lamp bulbs in your Lavatherm! They
produce too much heat, causing overheating under the lamp covering
hood and possible damage.
0 Disconnect the mains plug. With fixed connection: Screw-out the fuse
or switch-off the circuit breaker.
0 Screw-off the covering hood of the filament bulb. (The filament bulb is
located at the top behind the fill-in door; see Front view).
0 Replace the defective filament bulb.
0 Screw-on the covering hood over the filament bulb again.
1
Warning! For safety reasons the covering hood must be screwed-on.
Otherwise the dryer must not be operated.