Sony STR-DA5600ES - Manual (Page 112)

112 GB
Press MUTING and at the same
time while pressing DISPLAY.
1
Press ?/1 while pressing RM
SET UP.
The AMP and ZONE buttons flash.
2
Press AMP.
The ZONE button goes off, the AMP
button keeps flashing and the SHIFT
button lights up.
3
Press the numeric button 1 or 2
while the AMP button is
flashing.
When you press 1, the command mode is
set to AV SYSTEM 1. When you press 2,
the command mode is set to AV SYSTEM
2.
The AMP button lights up.
4
Press ENTER.
The AMP button flashes twice, then the
command mode setting process is
completed.
Using a bi-amplifier
connection
If you are not using surround back speakers
and front high speakers, you can use the
SURROUND BACK/ZONE 2 terminals for
the front speakers for use with a bi-amplifier
connection.
To connect speakers
Connect the jacks on the Lo (or Hi) side of the
front speakers to the FRONT A terminals,
and connect the jacks on the Hi (or Lo) side of
the front speakers to the SURROUND BACK/
ZONE 2 terminals. Make sure that metal
fittings of Hi/Lo attached to the speakers have
been removed from the speakers. Not doing so
may cause a malfunction of the receiver.
To set up speakers
1 Select “ Settings” from the menu,
then press or b.
2 Select “Speaker,” then press or b.
3 Select “Speaker Pattern,” then press
.
Switching the command mode of
the multifunction remote
commander
ZONE
?/1
AMP
ENTER
1, 2
RM SET
UP
SHIFT
Front speaker
(R)
Front speaker
(L)
Hi
Lo
Hi
Lo