Nilfisk-ALTO SCRUBTEC 571 - Manual (Page 15)

Nilfi sk ALTO Operator’s Manual - SCRUBTEC R Manual Steering Form No. 71274A Page -15-
Figure 15
Figure 16
How To Prepare the Machine For Operation
How To Install The Brush Or Pad on the BOOST machine
To install the brush or pad on the BOOST machine, follow this pro-
cedure:
1. Turn the key switch “ON”.
2. Put the brush switch in the “UP” position.
3. Turn the key switch “OFF”.
4. Go to the side of the machine.
5. Press on a brush or pad under the fl ex plates. See fi gure 15.
NOTE: When using a black pad, position pad on head.
Lower head and operate momentarily to affi x pad to
pad driver (if you have diffi culty, position pad on
fl oor and lower head then operate.)
How To Remove The Brush Or Pad on the BOOST
machine
To remove the brush or pad from the machine, follow this proce-
dure:
1. Turn the key switch “ON”.
2. Put the brush switch in the “UP” position.
3. Turn the key switch “OFF”.
4. Go to the side of the machine.
5. Pull downward on the brush or pad until it releases from the fl ex
plates. See fi gure 16.