Sony STR-DN1040 - Manual (Page 53)

53 US
T
une
r Ope
ra
tio
ns
You can enter the frequency of a station
directly by using the numeric buttons.
1
Press D.TUNING.
2
Press the numeric buttons to enter
the frequency, then press
.
Example 1: FM 102.50 MHz
Select 1
b 0 b 2 b 5 (b 0*)
Example 2: AM 1,350 kHz
Select 1
b 3 b 5 b 0
* Press 0 for Mexico model only.
• Adjust the direction of the AM loop
antenna (aerial) for optimum reception
upon tuning to an AM station.
• The tuning scale for direct tuning is shown
below.
* The AM tuning scale can be changed
(page 53).
If you cannot tune to a
station
“– – – .– – MHz” or “– – – – kHz” appears
and then the screen returns to the current
frequency.
Make sure you have entered the right
frequency. If not, repeat step 2. If you still
cannot tune to a station, the frequency may
not be in use in your area.
You can change the AM tuning scale to
either 9 kHz or 10 kHz using the buttons on
the receiver.
1
Press ?/1 to turn off the receiver.
2
While holding down TUNING
MODE, press ?/1 on the receiver.
The current AM tuning scale is
changed to 9 kHz (or 10 kHz).
To reset the scale to 10 kHz (or 9 kHz),
repeat the procedure above.
• Depending on the settings, the receiver may take
some time to change the AM tuning scale.
• All preset stations will be erased when you
change the tuning scale.
Tuning to a station
directly (Direct Tuning)
Tips
Area FM AM
USA, Canada,
Brazil 100 kHz 10 kHz*
Mexico 50 kHz 10 kHz*
Changing the AM tuning
scale
Notes
? /1
TUNING MODE