3d video images others – Sony VPL-HW30ES User Manual
Page 66
66
3D video images
Others
Symptom
Cause and Remedy
The video image does not
seem like 3D video images.
c Check if the 3D glasses are turned on (1 page 37).
c Make sure that the battery in the 3D glasses is charged.
c Check if the input source is HDMI.
c Set “2D-3D Display Sel.” to “Auto” or “3D” (1 page 55).
c Check if the input signals are compatible 3D signals (1 page
81).
c If no 3D signal is input from the 3D equipment connected to the
projector, restarting the connected 3D equipment may solve the
problem.
c The 3D glasses may not function effectively if the viewing or
projector position is too far from the 3D Sync Transmitter. (
c Check that the 3D Sync Transmitter is placed within the
specified range. (
c Turn off the projector, reconnect the 3D Sync Transmitter, and
then turn on the projector again. (
c The screen size is not appropriate. Set the zooming
magnification to low or watch the image from farther away from
the screen (
Symptom
Cause and Remedy
The fan is noisy.
c Check the setting of “Cooling Setting” in the Setup
menu.
c Make sure that the room temperature is not too high.
c Check the installation conditions. (1 page 13)
The number of fan rotation increases to maintain the product
reliability of the projector’s components in a room, where the
temperature is higher than normal. The fan noise becomes
slightly louder. The approximate normal temperature is 25°C.
The lens shift cannot be
adjusted.
c The lens shift cannot be adjusted over the range of movement.
Adjust the lens shift within the range of movement (
1
The projector and
connected equipment turn
On/Off, play back, and
operate at the same time.
c “Control for HDMI”, “Device Auto Power Off”, and “PJ Auto
Power ON” are set to “On”. Set them to “Off”.
For details, see “HDMI Setting” (