beautypg.com

Connecting to a 3d sync transmitter – Sony VPL-HW30ES User Manual

Page 28

background image

28

The optional 3D Sync Transmitter* is required to view projected 3D video images.

For details on the installation of the 3D Sync Transmitter*, refer to the operating
instructions supplied with the 3D Sync Transmitter.

CAUTION
Be sure to use straight-type LAN cable of up to 15 m labeled TYPE CM, and do not use
an extension cord.

• Turn off the projector before connecting the 3D Sync Transmitter, otherwise the 3D Sync

Transmitter is not recognized.

• The 3D SYNC connector is dedicated for the optional 3D Sync Transmitter. Do not connect

computers or other network devices, to avoid malfunction.

• When you connect to a TMR-PJ1, be sure to use a straight-type LAN cable (not supplied) labeled

Cat-7 (Category 7). If you use other than the specified cable, the 3D Sync Transmitter may
occasionally not work.

• Be sure to use a cable of up to 15 m, and do not use an extension cord. Also, keep the LAN cable

away from any AC power cords as much as possible.

• Up to one 3D Sync Transmitter can be connected to the projector. Never connect multiple 3D Sync

Transmitter units, as this may cause a malfunction.

* 3D Sync Transmitter is supplied with VPL-HW30AES.

Connecting to a 3D Sync Transmitter

Notes

Right side of the projector

3D Sync Transmitter
(not supplied)*

Connecting cable (Optional for TMR-PJ1)

: 3D sync signal flow

This manual is related to the following products: