Sony PCV-RS730G - Manual (Page 96)

3. Remove the cover. See Removing the cover .
4. Configure the jumpers on the new drive as a slave. See the configuration instructions supplied with your drive.
5. Detach the power and drive cables from the original hard disk drive that is preinstalled in your computer.
6. Release the drive holder from the chassis by removing the drive holder screw.
7. Slide the drive holder out.
Rem ov ing the driv e holder
8. Slide the new drive into the drive holder and align the holes on each side of the drive to the holes in the drive
holder.
9. Secure the drive to the drive holder with screws, through the holes on each side of the drive holder.
Attaching the driv e screws
Your new hard disk drive is supplied with the necessary screws. Do not overtighten these screws when securing
the new drive to the drive holder.
10. Realign the drive holder with the tracks on the inside of the chassis and slide the drive holder in completely.
11. Reinsert the drive holder screw and tighten to lock the drive holder back into position.
12. Reconnect the SATA and power connectors to the original drive. Page 96