beautypg.com

Asus AT3N7A-I User Manual

Page 22

background image

ASUS AT3N7A-I

1-13

3.

USB connector (10-1 pin USB910)
This connector is for a USB 2.0 port. Connect the USB module cable to this connector,

then install the module to a slot opening at the back of the system chassis. This USB

connector complys with USB 2.0 specification that supports up to 480 Mbps connection

speed.

Never connect a 1394 cable to the USB connector. Doing so will damage the motherboard!

The USB module cable is purchased separately.

4.

Chassis intrusion connector (4-1 pin CHASSIS)
This connector is for a chassis-mounted intrusion detection sensor or switch. Connect

one end of the chassis intrusion sensor or switch cable to this connector. The chassis

intrusion sensor or switch sends a high-level signal to this connector when a chassis

component is removed or replaced. The signal is then generated as a chassis intrusion

event.

By default, the pin labeled “Chassis Signal” and “Ground” are shorted with a jumper

cap. Remove the jumper caps only when you intend to use the chassis intrusion

detection feature.