9fcc part 68 – Sony VGN-FW490DEB User Manual
Page 9
9
FCC Part 68
This equipment complies with Part 68 of the FCC Rules and the requirements adopted by the ACTA. On the bottom
or back panel of the equipment is a label that contains, among other information, a product identifier in the format
US: AAAEQ##TXXXX. If requested, this number must be provided to the telephone company.
This modem uses the USOC RJ-11C telephone jack.
A telephone plug and jack used to connect this equipment to the premises wiring and telephone network must
comply with the applicable FCC Part 68 rules and requirements adopted by the ACTA. The REN is used to
determine the quantity of devices which may be connected to the telephone line.
Excessive RENs on the telephone line may result in the devices not ringing in response to an incoming call. In most,
but not all areas, the sum of the RENs should not exceed five (5.0). To be certain of the number of devices that may
be connected to the line, as determined by the total RENs, contact the telephone company. For products approved
after July 23, 2001, the REN for this product is part of the product identifier that has the format
US: AAAEQ##TXXXX. The digits represented by ## are the REN without a decimal point (e.g. 03 is a REN of
0.3). For earlier products, the REN is separately shown on the label.
If this equipment causes harm to the telephone network, the telephone company will notify you in advance that
temporary discontinuance of service may be required. But if advance notice is not practical, the telephone company
will notify the customer as soon as possible. Also, you will be advised of your right to file a complaint with the FCC
if you believe it is necessary.
The telephone company may make changes in its facilities, equipment, operations or procedures that could affect the
operations of the equipment. If this happens, the telephone company will provide advance notice in order for you to
make the necessary modifications in order to maintain uninterrupted service.
If trouble is experienced with this equipment, for repair or warranty information, please contact the Sony Customer
Information Service Center at 1-888-4-SONY-PC (1-888-476-6972), or write to the Sony Customer Information
Center, 12451 Gateway Blvd., Fort Myers, FL 33913, USA, or find Sony Customer Service on the Web site at
http://esupport.sony.com/EN/VAIO/. If this equipment is causing harm to the telephone network, the telephone
company may request that you disconnect the equipment from the network until the problem is resolved.
Repair of this equipment should be made only by a Sony Service Center or Sony authorized agent. For the Sony
Service Center nearest you, call 1-888-4-SONY-PC (1-888-476-6972), or visit the Sony online support Web site at
http://esupport.sony.com/EN/VAIO/.
Connection to a Party Line Service is subject to state tariffs. Contact the state public utility commission, public
service commission, or corporation commission for information.
If your home has specially wired alarm equipment connected to the telephone line, ensure the installation of this
equipment does not disable your alarm equipment. If you have questions about what will disable alarm equipment,
consult your telephone company or a qualified installer.
Please use a surge arrestor against electrical surges.
- VGN-FW490DAB VGN-FW455J VGN-FW490DDB VGN-FW490J VGN-FW490JEB VGN-FW490JDB VGN-FW490DCB VGN-FW465J VGN-FW490JFB VGN-FW490JCB VGN-FW480J VGN-FW490JEH VGN-FW490JBB VGN-FW490D VGN-FW490JET VGN-FW490Y VGN-FW488J VGN-FW490JFT VGN-FW450J VGN-FW490DFB VGN-FW490DBB VGN-FW400 VGN-FW486J VGN-FW485J VGN-FW490JGB VGN-FW468J VGN-FW495J VGN-FW463J VGN-FW448J VGN-FW490 VGN-FW490JAB VGN-FW490JFH VGN-FW460J VGN-FW449J