Sony VGN-SZ740EC - Manual (Page 12)

12
IC RSS-210 (Canada)
Operation is subject to the following two conditions: (1) This device may not cause harmful interference, and (2) this
device must accept any interference received, including interference that may cause undesired operation of the
device.
To prevent radio interference to the licensed service, this device is intended to be operated indoors and away from
windows to provide maximum shielding. Equipment (or its transmit antenna) that is installed outdoors is subject to
licensing.
L’utilisation de ce dispositif est autorisée seulement aux deux conditions suivantes : (1) il ne doit pas produire de
brouillage et (2) l’utilisateur du dispositif doit être prêt à accepter tout brouillage radioélectrique reçu, même si ce
brouillage est susceptible de compromettre le fonctionnement du dispositif.
Pour empêcher que cet appareil cause du brouillage au service faisant l’objet d’une licence, il doit être utilisé à
l’intérieur et devrait être placé loin des fenêtres afin de fournir un écran de blindage maximal. Si le matériel (ou son
antenne d’émission) est installé à l’extérieur, il doit faire l’objet d’une licence.
Personal Medical Devices
For PCG-6W1L and PCG-6W2L only
When Wireless WAN (EV-DO module) power is transmitting, it may affect the operation of cardiac pacemakers and
other implanted medical devices. If a minimum distance of 8 inches (20 cm) is kept between the PC and the
pacemaker, the risk of interference is reduced. If you have any reason to suspect that interference is taking place,
immediately turn off the WAN feature. Contact your cardiologist for more information.
For other medical devices, please consult the manufacture of the device.
Emergency Calls
For PCG-6W1L and PCG-6W2L only
The embedded EV-DO module does not support voice calls.
Disposal Information
Disposing mercury containing products (United States)
Lamp in this product contains mercury. Disposal of these materials may be regulated due to environmental
considerations.
For disposal or recycling information, please contact your local authorities or the Electronic Industries Alliance
(http://www.eiae.org).