Sony STR-DN1020 - Manual (Page 56)

56 GB
D:\NORM'S JOB\SONY HA\SO0155\STR-DN1020_PMRF 03\4273051141_GB\GB04GET_STR-
DN1020-CEL.fm masterpage: Left
STR-DN1020
4-273-051-14(1)
Tip
Adjust the direction of the AM loop antenna
(aerial) for optimum reception upon tuning to
an AM station.
3
Press .
If you cannot tune to a station
“– – – .– – MHz” appears and then the screen
returns to the current frequency.
Make sure you have entered the right
frequency. If not, repeat step 2. If you still
cannot tune to a station, the frequency may not
be in use in your area.
(USA and Canada models only)
You can change the AM tuning scale to either
9 kHz or 10 kHz using the buttons on the
receiver.
1
Press ?/1 to turn off the
receiver.
2
While holding down TUNING
MODE, press ?/1 on the
receiver.
The current AM tuning scale is changed
to 9 kHz (or 10 kHz).
To reset the scale to 10 kHz (or 9 kHz),
repeat the procedure above.
Notes
• Depending on the settings, the receiver may take
some time to change the AM tuning scale.
• All preset stations will be erased when you change
the tuning scale.
Presetting FM/AM radio
stations
(Preset Tuning)
You can store up to 30 FM and 30 AM stations
as your favorite stations.
1
Tune to the station that you
want to preset using Auto
Tuning (page 55) or Direct
Tuning (page 55).
2
Press TOOLS/OPTIONS.
The option menu appears.
3
Select “Memory”, then press
or b.
4
Select a preset number, then
press .
The station is stored as the selected preset
number.
5
Repeat steps 1 to 4 to store
another station.
You can store station as follows:
• AM band: AM 1 to AM 30
• FM band: FM 1 to FM 30
Changing the AM tuning scale
?/1
TUNING MODE
V/v/B/b,
TOOLS/
OPTIONS