Sony MDS-NT1 - Manual (Page 6)

6 GB
Hooking Up
To a wall outlet via the
supplied AC power adaptor
MDS-NT1
To active
speakers, etc.
To headphones
To the USB port
on your computer
Computer
USB cable (supplied)
Do not use a USB hub
between the MD deck
and the computer. Be
sure to connect the MD
deck directly to the
computer with the
supplied USB cable. Insert the connector into the port fully
with the mark facing upward.
The shielded interface cable
recommended in this manual must be
used with this equipment in order to
comply with the limits for a digital
device pursuant to Subpart B of Part
15 of FCC Rules.
To a USB port
Notes
• Make sure each plug is straight when you insert it.
Inserting it at an angle may damage the connector
parts.
• Be sure to install the OpenMG Jukebox software to
your computer before you connect the MD deck and
your computer. Otherwise, the computer may select
an inappropriate driver for the MD deck when you
connect them, and the MD deck may not work
correctly.
The [Add New hardware wizard] may appear when
you connect the MD deck to the computer. If this
happens, click [Cancel.]
• Sound output is not supported when you connect
the MD deck to the computer by the supplied USB
cable alone. Sound from the MD deck requires the
connection of headphones or active speakers, etc. to
the MD deck (see page 5).
• To output sound from the MD deck to the speakers
of the connected computer, use the supplied audio
connecting cord (a stereo mini-plug is provided on
both ends) or a resistance-free, equivalent
commercially available product to connect the
LINE OUT jack on the MD deck with the audio
input jack on the computer.
• Do not disconnect the USB cable while operating
the MD deck from the connected computer. Be sure
to stop the recording or playback operation before
disconnecting the USB cable.
USB cable