Sony MDS-NT1 - Manual (Page 5)

Location and Function of Parts
5 GB
Rear Panel Parts Description
1
2 3 4
Notes
• Full performance of the MD deck is not guaranteed
when it is connected to the computer through a
USB hub or USB extension cord. Be sure to
connect the MD deck directly to the computer with
the supplied USB cable.
• Do not connect the supplied AC power adaptor to a
switched AC outlet (e.g., on an amplifier).
• Use only the supplied AC power adaptor. Do not
use any other AC power adaptor.
Polarity of the plug
The shielded interface cable recommended in this
manual must be used with this equipment in order to
comply with the limits for a digital device pursuant to
Subpart B of Part 15 of FCC Rules.
• Before outputting sound through the headphones, it
is recommended that you turn the volume down
completely, and then gradually turn up the volume
to the desired level while listening to the sound.
1 DC IN 9V jack
Connect this jack to a wall outlet via the supplied
AC power adaptor to power the MD deck.
2 USB port
Connect this port to a USB port on your
computer with the supplied USB cable.
3 Headphones jack and PHONE LEVEL
control
Connect a headphones plug to this jack.
Turn the PHONE LEVEL control to adjust the
volume of the connected headphones.
4 ANALOG OUT jack
Connect active speakers, etc. to this jack with the
supplied audio connecting cord (stereo mini-plug
×
1 y stereo mini-plug
×
1) or optional audio
connecting cord (stereo mini-plug
×
1 y phono
plug
×
2).
or