American Dynamics ControlCenter ADCC0200 User Manual
Controlcenter
This manual is related to the following products:
Table of contents
Document Outline
- Chapter 1: About the ADCC0200 and ADCC0300 Keyboard
- Key Features
- ADCC0200 and ADCC0300 Keyboard Overview
- Feature Quick Reference
- Chapter 2: Connection and Setup
- Ancillary Equipment
- MP-KMI Keyboard Matrix Interface
- Installation Precautions
- Connections for Cable Distance of Greater than Seven Feet (RS232 Mode)
- Connections for Cable Distance of Seven Feet or Less (RS232 Mode)
- Multiple Keyboards on an RS485 Network
- Terminating/Biasing the RS485 Network
- Multiple Keyboards on an RS232 Network
- Chapter 3: Basic Operations - Operate Mode (ADCC0200 and ADCC0300)
- User Numbers and Passcodes
- Logging On to the System
- Logging Off from the System
- Keyboard Display
- Selecting Monitors
- Calling a Camera to View on a Monitor
- Controlling a Camera's Pan, Tilt and Zoom
- Controlling Camera Focus
- Controlling the Camera Iris
- Controlling Camera Flip
- Auto Iris
- Auto Focus
- Calling Presets
- Running Patterns
- Dome Camera DirectSet
- Running Tours
- Holding a Tour
- Restarting a Tour on Hold
- Stepping through a Tour
- Reversing a Tour
- Stopping a Tour
- Calling Salvos (RS232 only)
- Calling Views (RS485 only)
- Acknowledging Alarms
- Auxiliaries
- Setting the Keyboard Display Contrast
- Enabling or Disabling the Keyboard Sounder
- Viewing Satellite Sites
- Operating a VCR or Digital Recorder
- Cancel VCR/DVR mode
- Locking and Unlocking a Camera (RS232 only)
- Telemetry Enable/Disable (RS485 only)
- Initiating F1 Key Commands (RS232 only)
- Chapter 4: Programming with the ADCC0200/ADCC0300 Keyboards
- Entering Program Mode (RS232 only)
- Exiting Program Mode (RS232 only)
- Matrix Menu
- Dome Menu Functions
- Navigating Dome Camera Menus
- Setting Presets
- Programming Dome Patterns
- Defining Patterns
- Clearing Patterns
- Initiating F2 Key Commands (RS232 only)
- Chapter 5: Installer Functions
- Entering the Special Configuration Menu
- Setting the Keyboard Address
- Setting the Number of Keyboard Retries
- Setting the Network Timeout Period
- Setting the Baud Rate
- Disabling/Enabling the Sounder
- Selecting RS485 or RS232 mode
- To Reset the Keyboard to its Factory Defaults
- Selecting Auto Repeat or Make/Break Keypress Mode
- Setting the Passcode (Program Lock) Function
- Appendix A: ADCC0200/ADCC0300 VCR Reprogramming
- Appendix B: Monitor Arming Commands
- Appendix C: Troubleshooting
- Appendix D: Specifications
- Index
- Index