American Dynamics ControlCenter ADCC0200 - Manual (Page 29)

21
Keyboard Installation and Operation
Running Patterns
A pattern is a series of pan, tilt, zoom, and focus commands defined for a dome camera.
A pattern is programmed in real time, which means that the dome remembers each
pattern segment in the actual time it takes the operator to execute a command.
To run a pattern:
1. Call the camera that the pattern will run on.
2. Enter the pattern number using the numeric keys. The number entered will
appear on the right hand side of the top line of the LCD display.
3. Hold down the SHIFT ( ) key and press the PATTERN ( ) key.
Dome Camera DirectSet
The DirectSet feature allows certain dome camera functions to be accessed quickly from
the keyboard. Please note that this feature is not available on some dome cameras or
controller/matrix systems.
To access the DirectSet menu:
1. Call a monitor.
2. Call a suitable dome camera to command of the keyboard.
3. Press the DIRECTSET ( ) key.
The dome camera's DirectSet menu will be displayed on the currently selected monitor.
Note that the menu options shown depend on the dome camera in use.
To call a DirectSet function:
1. Enter the number of the function using the numeric keys.
2. Press the DIRECTSET ( ) key.
For example if a dome flip function was required, enter 3 and press the DIRECTSET key.
If the number for the DirectSet feature is already known to the operator, it can be entered
on the numeric keypad and the DirectSet key pressed directly. It is not necessary to call
the DirectSet feature menu to the monitor.
0 TOGGLE DIRECTSET MENU
1 DOME CONFIG MENU
2 AUTO IRIS/AUTO FOCUS
3 FLIP
4 PEEL PATTERN
10 NIGHT MODE
11 DAY MODE
12 AUTO DAY/NIGHT MODE
13 WDR ON
14 WDR OFF
255 RESET DOME