Argus Camera DC3200 User Manual

Page 37

Troubleshooting :

Before you decide the camera is faulty, check the following hints or instructions.

1. No Power

The battery is exhausted, inverted polarities

2. No Photo is taken

The internal memory or CF card is full

3. Can't use flash

1. It is set to suppress flash mode
2. Battery power is low.

4. Image too dark with flash

1. The subject is too far away
2. Your fingers covered the flash.

5. Image is blurred

The lens is soiled

6. Can't erase the photo It is

protected.

Unprotect it.

7. LCD monitor is off

The Mode Dial is set incorrectly

8. No display on the status LCD The camera is auto power off
9. Card Full is seen No CF card

is inserted.

The card is full

10. The object is too dark

1. Change the position to avoid backlit

problem.

2. Use eV compensate. Add 1eV or 1.5eV.

11. The object is unclear

Environment too dark.

Use flash or tripod.

12. The object color is too yellow Change the White Balance to other settings.
13. I cannot use the CF card

1. Power off and then turn on the unit.
2. Check if the CF card is fully inserted.

14. I cannot use the video camera Make sure you have selected 'silent video'

mode

15. I am using “Easy-CD Creator

1.DC3200 Digital Camera’s installation CD

(version 4.X or below) and I

includes an “auto-check” program to detect

have problem installing the

if your PC has any software conflicts

camera driver, what should

between PC’s own devices and the camera.

I do?

If the “auto-checker” detects existence of
software conflicts, it will recommend and
guide the user to download the updated
driver/file from appropriate website to solve
the conflict problem.

2. If you cannot download the driver from

website for some reasons, try following the
following procedures:

a. Insert the DC3200 Digital Camera

installation CD into the CD-ROM drive

b. Look for the file “recover.bat” stored in

the CD

c. Double-click the file to initiate the

recovering process

d. Restart your computer