Sony KDS-70R2000 - Manual (Page 48)

48 GB
Replacing the lamp
The Projection lamp, like all lamps, will eventually
lose brightness and functionality which affects the
overall performance of your TV. How long the Lamp
maintains its brightness will vary depending upon
your usage and environmental conditions. To
maintain the quality of your viewing experience, Sony
recommends that you replace the Lamp (1) when the
screen becomes dark or the colour looks unusual; (2)
when
on the front of the TV flashes; (3) after
approximately 8,000 hours of use (for KDS-55A2000)
or 4,000 hours of use (for KDS-70R2000); or (4) when
the lamp replacement message appears on the TV
screen.
WARNING
Electric appliances can cause fire or high temperature,
resulting in injury or death. Be sure to follow the
instructions below.
• Use only a Sony XL-5200 (for KDS-55A2000, not
supplied) or XL-5300 (for KDS-70R2000, supplied)
replacement lamp for replacement. Use of any other lamp
may damage the TV.
• Do not remove the lamp for any purpose other than
replacement. Doing so may cause injury or fire.
• Do not put flammable materials and metal objects inside
the lamp receptacle of the TV after removing the lamp.
Doing so may cause fire or electrical shock. Do not touch
the lamp receptacle once the lamp has been removed.
• When the lamp eventually burns out, you may hear a
noticeable “pop” sound. This is normal and it is inherent
to this type of lamp.
• In rare instances, the bulb may pop inside the lamp unit,
but the lamp unit is designed to contain all of the broken
glass pieces inside the lamp unit.
• This TV’s lamp contains mercury and should be disposed
of properly. Consult your local authorities regarding safe
disposal. The material contained in this lamp are similar to
those of a fluorescent lamp, so you should dispose of it in
the same way.
1
Switch off the TV. Wait several minutes,
then unplug the mains lead.
(The cooling fan will continue to operate for
about two minutes after switching the TV
off.)
2
Wait at least 30 minutes after unplugging
the mains lead to allow the lamp to cool
down before replacing it. To avoid being
burned, do not touch the lamp receptacle
once the lamp has been removed.
3
Take the new lamp out of its package.
Do not touch the glass portion of the new
lamp.
Notes
• Do not shake the lamp. Vibration can damage the
lamp or shorten its life.
• Avoid touching the front glass of a new lamp or the
glass of the lamp receptacle. This may reduce picture
quality or lamp life.
4
Remove the outside lamp cover.
KDS-55A2000
KDS-70R2000
5
Remove the lamp door.
Turn the screw counterclockwise. Then
slide the lever to the left (KDS-55A2000) or
turn the knob to the left until the marks on
the lid and the case line up
(KDS-70R2000). Remove the door.
KDS-55A2000
KDS-70R2000
Additional Information