Aussie 8462 - Manual (Page 17)

· Open Hood before lighting the grill to prevent an
explosion from gas build-up.
· Always inspect the gas hose and regulator
assembly
before each use. If the hose is cut, damaged, or
showing signs of excessive abrasion or wear, do
not use the LP gas grill. Contact the
manufacturer, as the hose must be replaced with
an assembly specified by the manufacturer prior
to further use of the LP gas grill.
How to manually light your LP gas grill
1) Open Hood
2) Important: The LP gas cylinder valve must be
opened first before turning the control knobs on the
grill. Turn the handle on the LP cylinder valve counter-
clockwise until it stops.
3) Insert a lit match through one of the match-lighting
holes underneath the front control panel on the grill.
(See figure below).
4) Locate the control knob that corresponds to the match
lighting hole that you are using. Push in and turn the control
knob counter-clockwise until a click is heard.
WARNING: If the burner fails to ignite after
following the above procedure, turn all the knobs to
the off position and close the valve on the LP cylinder.
Wait five minutes and repeat all of the above manual
lighting procedures. If the grill still fails to light, see
the Troubleshooting page.
5) Light the remaining burners from left to right by turning the
control knob counter-clockwise. Your grill has a crossover
ignition system that allows the burners to light successively
off one another. Confirm each burner is lit before
lighting another burner.
6) After ignition, burners should be burned at the “high” position
for 3-5 minutes in order to preheat the grill. This process
should be done before every cooking session. The hood
should be closed during preheating.
WARNING: If a burner goes out during the cooking
cycle, turn all knobs to the off position and close the valve
on the LP cylinder. Open hood and wait five minutes before
attempting to relight the grill.
Manual Lighting of the Grill
4. Push in and turn
control knob
counter-clockwise
to the “High”
position.
3. Insert a lit match
through the match
lighting hole in bottom
left side of Control
Panel
2. Turn LP cylinder handle
counter-clockwise - “ON”
1. Open hood
17