AEG 111 K - W/D/G - Manual (Page 17)

17
Fitting the hob to the worktop
Before fitting the hob into the
cut out, a sealing gasket
supplied with the hob must be
fitted to the edge of the cut
out. It is essential that no gaps
are left in this seal in order to
prevent spillage near the hob
seeping into the cabinet below.
1) Place the sealing
gasket all around the
edge of the cut out.
2) Place the hob into
the cut out and
secure it by means of
the relevant fixing
clamps and screws, as
shown in the diagram.
3) Remove the excess seal
The edge of the hob forms a double seal which prevents the ingress of
liquids.
☞
FO 0199
a
Seal