AEG LAVATHERM 57520 - Manual (Page 28)

Something not working?
28
If you do not find the required information in this manual to remedy a
disturbance, please call the customer service.
The drum illumination does
not work
The programme selector
is in the
Y OFF position
Turn the programme
selector dial to
O LIGHT
The bulb needs replacing Replace bulb
Display
Z EMPTY WATER is
lit
Condensate container full
Empty the condensate
container
Z EMPTY WATER indicator
illuminated, even though the
container has already been
emptied
Foreign bodies, e. g. ani-
mal hairs, can block the
inlet nozzle as well as the
valve on the end of the
container
With the container pulled
out, switch on the
appliance momentarily.
The blockage can be
removed from the contai-
ner shaft or the hair clea-
ned out of the valve
The dryer terminates the
drying process automatically:
> END is displayed shortly
after programme start
Too dry or too little
laundry filled in for the
selected programme
Select time programme or
higher drying stage (e.g.
1 R EXTRA DRY instead
of 2 R INTENSIVE DRY)
The drying process takes
unusually long.
Note: The drying cycle ends
automatically after 3 hours:
-
z DRYING and
V COOLING indicators are
flashing
- acoustic signal sounds
The heat exchanger unit
is covered with fluff Clean the heat exchanger
unit
Fluff filter is clogged Clean the fluff filter
W SPECIAL CARE button
pressed and too much
laundry filled in
Check the programme
selection:
W SPECIAL
CARE button appropriate
only for laundry amounts
up to 2.5kg
Too much laundry
filled in Reduce the amount of
laundry filled in
Laundry too damp
Pre-dry the laundry more
thoroughly
Symptom Possible cause Solution