Karcher BD 530 Bp User Manual

Page 12

English

Press control switch.

Note
If the brush motor does not run when
switched on, then brush motor is to be
released by pulling the machine back-
ward.

Perform the cleaning operation.

Reducing the speed: Turn the button
in "–" direction.

Increasing the speed: Turn the but-
ton in "+" direction.

Set the water quantity at the regula-
tion knob according to the dirt level
and the type of flooring.

Note
Carry out initial cleaning attempts with
low quantity of water. Slowly increase
the water quantity till the desired clean-
ing result is achieved.

To improve the vacuuming result on
tiled floors the vacuum bar can be
turned to an oblique position of up to 5°.

Loosen cross-handles.

Turn the vacuum bar.

Tighten the cross-handles.

If the vacuum result is unsatisfactory the
inclination of the straight vacuum bar
can be modified.

Release the wing nuts.

Tilt the vacuum bar.

Tighten the wing nuts.

Turn the lever downwards; the vacu-
um bar is lowered.

Setting the advance speed

Setting the water quantity

Setting the Vacuum Bar

Oblique position

Inclination

Lower the vacuum bar