Karcher BR 40-25 C Bp Pack - Manual (Page 24)

– 8
The battery control display shows the
charging status of the batteries when the
charger has been connected:
Note
The appliance is switched off automatically if
the battery has been fully discharged (battery
indicator glows red). You can restart the appli-
ance only after you have fully charged the bat-
tery.
You can acquire additional sets of batteries
to avoid the waiting time when the batteries
are getting charged. You can then replace
the empty battery set in the appliance by a
charged set of batteries.
Note
The spare battery set must show a mini-
mum voltage of 25.8 V when you connect it
to the appliance. If the voltage is lower, the
electronic mechanism to prevent total dis-
charge will block the appliance startup. In
such a case you would need to fully charge
the battery.
To improve the vacuuming result on tiled
floors the vacuum bar can be turned to an
oblique position of up to 5°.
 Release the wing nuts.
 Turn the vacuum bar.
 Tighten the wing nuts.
If the vacuum result is unsatisfactory the in-
clination of the straight vacuum bar can be
modified.

Release the wing nuts.
 Tilt the vacuum bar.
 Tighten the wing nuts.
 Turn the running gear to the front with
your foot.
 Reducing the speed: Turn the wheel in
– direction.
 Increasing the speed: Turn the wheel in
+ direction.
Battery control display
40-100% glows green
20-40% glows yellow
0-20% slowly blinks red
empty glows red
Spare batteries
Setting the Vacuum Bar
Oblique position
Inclination
Setting the advance speed (BD
model only)
24 EN