Karcher CV 66-2 - Manual (Page 10)

10
English
Î Large waste such as cardboard cups,
cardboard plates, strings and similar ob-
jects must be picked up prior to vacuum-
ing.
Î Insert the plug into the socket.
Î Set the appliance switch to "ON".
Î Ride along the surface to be cleaned
with a suitable, even speed.
Î Heavy soiling must be worked on several
times or slower.
ṇ
Warning!
Risk of damage to the floor covering. Do not
operate the appliance on the spot.
Î
Due to the one-sided arrangement of the
brushes, the right side of the appliance
can clean all the way to the edge.
Î If the display for a full filter bag is illumi-
nated, switch the appliance off and re-
place the filter bag.
ṇ
Warning
Risk of injury. Pull the plug from the mains
before carrying out any tasks on the appli-
ance.
Î If needed, shake the contents of the filter
bag downward.
Î Check the mains connection cable for
damages. Replace the defective mains
cable.
Î Clean below the appliance.
Î Remove fibres, hair and strings from the
brush rollers.
Î Check and clean seals, replace dam-
aged seals.
Î Clean brushes and check for wear and
tear.
The brushes are considered worn, if the
bristles have the same length as the yel-
low indicator bristles.
Î Clean the motor protection filter on the
bottom of the filter chamber and check
for damage.
Î Remove the wheels, clean the axles and
apply a thin coat of silicone grease.
Î Open lid of filter chamber.
Î Pull the filter bag off the connection hub
and remove them from the appliance.
Î Insert new filter bag (see "Replacing filter
bag").
Î Disconnect the main plug from the sock-
et.
Î Tilt the appliance backward and store it
on the pushing handle.
1 Locking plate
2 Bearing block
3 Brush roller
4 Driver pin
Vacuuming
Maintenance and care
Maintenance intervals
Daily
Weekly
Monthly
Half-yearly
Replacing the filter bag
Replacing the brush rollers