American Dryer Corp. ADG-530D II - Manual (Page 34)

30
H. PREPARATION FOR OPERATION
The following items should be checked before attempting to operate the dryer:
1. Read and follow ALL “CAUTION,” “WARNING,” and “DIRECTION” labels attached to the dryer.
2. Check incoming supply voltage to be sure that it is the same as indicated on the dryer data label located
behind the left coin control panel on the right wall (refer to Section IX of this manual).
3. Check to assure that the dryer is connected to the type of heat/gas indicated on the dryer data label.
4. The sail switch damper assemblies are installed and preadjusted at the factory prior to shipment. However,
each sail switch adjustment should be checked to assure this important safety control is functioning.
5. Check bolts, nuts, screws, terminals, and fittings for security.
6. Be sure ALL gas shutoff valves are in the open position.
7. Be sure ALL back panels (guards) and electric box covers have been replaced.
8. Check ALL service doors to assure that they are closed and secured in place.
9. Rotate the baskets (tumblers) by hand to be sure they move freely.
I. PREOPERATIONAL TESTS
ALL dryers are thoroughly tested and inspected before leaving the factory. However, a preoperational test
should be performed before the dryer is publicly used. It is possible that adjustments have changed in transit.
1. Turn on electrical power to the dryer.
a. Open ALL gas shutoff valves.
2. Computer System Operational
a. COIN MODELS ONLY
1) The light emitting diode (L.E.D.) display(s) will flash back and forth between “FILL” and the
amount needed to start the dryer (i.e., “25”), which means that the dryer is available and 25¢ is
required to start it.
2) Insert the proper number of coins into coin acceptor. Once the correct amount needed to start the
dryer has been inserted, the L.E.D. display will read “PUSH.”
3) Start the dryer by pressing the desired setting (i.e., LOW TEMP). The L.E.D. display will now
read selection (setting) made and the amount of time vended (i.e., “LO 10”).