Karcher HDS 13-20-4 S EU - Manual (Page 27)

– 6
ṇ
Warning
Long hours of using the appliance can
cause circulation problems in the hands on
account of vibrations.
It is not possible to specify a generally valid
operation time, since this depends on sev-
eral factors:
– Proneness to blood circulation deficien-
cies (cold, numb fingers).
– Low ambient temperature. Wear warm
gloves to protect hands.
– A firm grip impedes blood circulation.
– Continuous operation is worse than an
operation interrupted by pauses.
In case of regular, long-term operation of
the device and in case of repeated occur-
rence of the symptoms (e.g. cold, numb fin-
gers) please consult a physician.
ƽ
Danger
Switch the appliance off prior to replacing
nozzel and activate hand spray gun until
device is pressureless.
1 Bar graph - fuel fill level
2 Bar graph - detergent 1 fill level
3 Bar graph - detergent 2 fill level
– The operation and maintenance sym-
bols are displayed consecutively for 3
seconds each, just like in a slideshow.
– The error symbols remain until the ap-
pliance is switched off.
1 Operating with cold water
2 Eco operation (hot water max. 60 °C)
3 Operating with hot water/steam
Î Set appliance switch to desired operat-
ing mode.
The device starts briefly and turns off, as
soon as the working pressure is reached.
Note: If the error symbol appears on the
display during operation, immediately
switch off the appliance and remove the er-
ror; see "Help for errors".
Î
Release the trigger gun.
When activating the hand spray gun the de-
vice switches back on.
Note:If no water comes out of the high
pressure nozzle, vent pump. Refer to "Help
with malfunctions - appliance is not building
up pressure".
Î Set temperature regulator to desired
temperature.
30 °C to 95 °C
– Clean with hot water.
100 °C to 150 °C
– Clean using steam.
ƽ
Follow the instructions given in the sec-
tion "Operation with steam"!
Safety instructions
Replace the nozzle.
Display
Operating modes
0/OFF =Off
Turning on the Appliance
Adjust cleaning temperature.
27 EN