Karcher KM 130-300 R Lpg - Manual (Page 28)

- 11
 Park the sweeper on an even surface.
 Connect air pressure testing device to
tyre valve.
 Check air pressure and adjust if re-
quired.
 For permissible tyre air pressures see
"Technical data".
 Clean the dust filter with the filter clean-
ing button.
ṇ
Warning
Empty waste container before replacing
dust filter. Wear a dust mask when working
around the dust filter. Observe safety regu-
lations on the handling of fine particulate
material.
1 Lock of appliance hood
2 Cover
 Open the lock, remove the star grip
screw to do this.
 Fold cover forwards.
1 Lock
2 Filter cover
 Open filter cap.
 Fold the filter vibrator forward.
 Replace the dust filter.
 Close the filter cover.
The V-Belt must deflect approx. 7-9 mm at
a pressure of 10 kg.

Get the V-belt tension adjusted by an
authorized customer service.
1 Lock
2 Air filter housing
 Open the lock.
 Remove the air filter housing.
 Replace the air filter insert.
Note: Installation position with blowout
opening pointing down (see illustra-
tion).
 Unscrew the wing nut from the centrifu-
gal separator.
 Clean the centrifugal separator.
 Unscrew the head lamps.
 Take out the head lamps and pull out
the plug.
Note: Note the positions of the plugs.

Dismantle the head lamps.
 Dismantle the head lamp casing and
hold it horizontally because the lamp
unit is not fastened.
 Unlock the bracked and take out the
bulb.
 Insert new bulb.
 Reinstall in reverse sequence.
Note: Remove the glass of the direction-in-
dicator lamp from its casing to replace the
bulb.
 Open the fuse holder.
 Check the fuses.
Note: The fuse FU 01 is located in the en-
gine compartment.
 Replace defective fuses.
Note: Only use fuses with identical safety
ratings.
Check the tyre pressure
Manually clean the dust filter
Replacing dust filter
2
1
Check and adjust the V-Belt
Check air filter and replace, if necessary
Changing the headlight bulb (option)
Changing the blinker bulb (option)
Replacing fuses
FU 01 Main fuse 60 A
FU 02 Gas cylinder fill level indi-
cator 5 A
FU 03 Safety relay
Multifunction display 10 A
FU 04 Blinker switch 10 A
FU 05 Time relay
Seat contact switch 10 A
FU 06 Blower 25 A
FU 07 Program selection switch
Waste container func-
tions 10 A
FU 08 Horn 10 A
FU 09 Left lighting 7,5 A
FU 10 Right lighting 7,5 A
FU 11 Front work lights (low
beam) 10 A
FU 12 Vibrator system
Beacon lamp 20 A
FU 13 Water pump 10 A
28 EN