Karcher T 9-1 Bp - Manual (Page 10)

10
English
Î Pull out the roller bearing and clean it.
Î Insert the roller bearing.
Î Assemble the brush roller. Ensure that
the gears of the toothed belt match with
the cogs.
Î Replace the housing lid.
Î Replace the hood and press it evenly
until it locks in.
The mechanism for protection against over-
heating switched off the motor when it is
overloaded, for e.g. because the brush roll-
er is blocked.
Î
Pull out the mains plug.
Î Check the brush roller for impurities and
remove any objects that may be block-
ing its movement.
Î Allow device to cool down.
Wait for approx. 2 minutes before restarting
the appliance.
Note
The electrical suction brush runs only when
a charged battery of the vacuum cleaner is
in place.
Troubleshooting
Specifications
Voltage 24 V (DC)
Protective class III
Output of the
brush motor
30 W
Speed 3600 ±200 1/min
Sweeping width 240 mm
Brush roller
replaceable
Brush drive Toothed belt with elec-
tronic protection against
overloading
Height 60 mm
Depth 120 mm
Width 280 mm
Weight ~ 1 kg