Karcher B 60 W - Manual (Page 13)

- 4
 Reducing the speed: Turn the button in
"–" direction.
 Increasing the speed: Turn the button in
"+" direction.
Caution
Risk of damage to the floor covering. Do
not operate the appliance on the spot.
Note
The machine is designed in such a way that
the brush head protrudes on the right. This
helps in working in a proper way even close
to the edges.

Turn the program selection switch to
the desired cleaning program.
 Press the pedal for lowering the clean-
ing head downwards slightly and then
move it to the left. This unlocks the ped-
al. Release the pedal slowly upwards.
The cleaning head is lowered.
Note
The brush motor comes to a halt when the
machine stops and when there is overload.
 Pull the lever out and press it down; the
vacuum bar is lowered.
Note
For cleaning tiled floors, set the straight
vacuum bar in such a way that cleaning is
done at right angles to the joints.
The inclined position and the inclination of
the vacuum bar can be adjusted to achieve
better suction results (see "Setting the Vac-
uum Bar").
If the wastewater reservoir is full, the float-
er will close the suction opening and the suc-
tion turbine will run at a higher speed. If this is
the case, shut the vacuum off and drive to
empty the wastewater reservoir.
 Close the regulatory button for setting
the water quantity.
 Release the safety switch.
 Set the program selection switch to suc-
tion or vacuuming.
 Lift the cleaning head.
 Briefly drive forward and suck of the re-
maining water.
 Raise the vacuum bar.
 Disconnect the main plug from the
socket.
ṇ
Warning
Please observe the local provisions regard-
ing the wastewater treatment.

Take the water discharge hose from the
support and lower above a suited col-
lection device.
 Crush or bend the dosing equipment.
 Open the lid of the dosing equipment.
 Drain off the dirt water - regulate the
water quantity by pressing or bending.
 Rinse the wastewater reservoir with
clean water or with the rinsing system
for the wastewater reservoir (option).
 Loosen the lid for emptying the fresh
water - do not remove it fully. Drain wa-
ter.
 To rinse the fresh water reservoir, re-
move the cover completely and remove
the fresh water filter.
ƽ
Danger
Risk of injury! When loading or unloading
the machine, it may only be operated on
gradients of max. incline (see "Technical
Specifications"). Drive slowly.
Caution
Risk of injury and damage! Observe the
weight of the appliance when you transport it.

Raise the cleaning head to avoid dam-
age to the brushes.
 Remove the brush to avoid damage to
the brushes.
 When transporting in vehicles, secure
the appliance according to the guide-
lines from slipping and tipping over.
Caution
Risk of injury and damage! Note the weight
of the appliance in case of storage.
This appliance must only be stored in inte-
rior rooms.
ƽ
Danger
Risk of injury. Pull the plug from the mains
before carrying out any tasks on the appli-
ance.

Drain and dispose of the dirt water and
the residual fresh water.
Setting the Advance Speed
(BD cleaning head only)
Cleaning
Lower the cleaning head
Lower the vacuum bar
Shutting Down the Appliance
Drain off dirt water
Drain off clean water
Transport
Storage
Maintenance and care
13 EN