Karcher MV 4 - Manual (Page 15)

– 9
Caution
Always work with an inserted flat
fold filter - during wet as well as
dry vacuum cleaning!
Illustration

Release and remove the appliance
head.
 Turn the container, press in the steering
roller in the openings at the base of the
container till the end-point.
 Insert and lock the appliance head.
Illustration

Connect accessories.
Illustration

Plug in the main plug.
Illustration

Turn on the machine.
Caution
Work with a dry flat fold filter on-
ly.
Check the filter for damage prior
to installation and replace as
necessary.
Illustration

Recommendation: To vacuum fine
dust, use the filter bag.
– The filling level of the filter bag depends
on the dirt that is sucked in.
– The filter bag needs to be replaced
more frequently while sucking in fine
dust, sand, etc.
– Clogged filter bags can burst - therefore
make sure to replace the filter bag in a
timely manner!
Caution
Vacuum cold ashes only when
using a pre-filter.
Order no. basic design: 2.863-139.0, pre-
mium design: 2.863-161.0.
 For vacuuming up moisture or wetness
pay attention to the correct floor nozzle
insert and connect the corresponding
accessories.
ṇ Warning
Immediately switch the appli-
ance off or pull the power plug if
foam forms or liquids escape!
Do not use a filter bag!
Note: If the container is full, a float closes
the suction opening, and the appliance
works at a higher speed. Switch off the ap-
pliance immediately, and empty the con-
tainer.
Illustration

Turn off the appliance.
Illustration

Hook the floor nozzle into the parking
position.
 Turn off the appliance and disconnect
the mains plug.
Illustration

Remove the appliance head and empty
the reservoir filled with wet or dry dirt.
Illustration

Store the accessories and the mains
cable on the appliance and store the
appliance in dry rooms.
Operation
Before Startup
Start up
Dry vacuum cleaning
Information filter bag
Wet vacuum cleaning
Interrupting operation
Finish operation
Empty the container
Storing the appliance
15 EN