Karcher BR 47-35 ESC EU - Manual (Page 12)

12
English
Î Set the appliance switch to 'dry vacuum
cleaning' position. Dry vacuum cleaning
is activated.
Î Let the pump pressure fall to 0 bar.
Î Set the appliance switch to "0".
Î Release the foot pedal.
Î Activate the lever to lock and the pedal to
raise the brush head. Brush head is
raised.
Î Release the rear wheels.
Î Drive out the machine from the working
position and the podium until it is on firm
ground.
Î Pull out the mains plug.
Î Drain off and disose the remaining deter-
gent fluid.
Î Drain out the dirt water and dispose it off.
Î Clean the inside and outside of the ma-
chine. Rinse the tanks with clear water.
Î Store the machine in a frost-free room on
an even and clean floor.
Î Lock the rear wheels.
Î Remove the cordon from the travellator/
escalator only when the entire working
area is dry again. There is risk of acci-
dent on account of slipping even if the
travellator/ escalator is slightly moist.
ƽ
Danger
Risk of injury! Before doing any work on the
machine:
Î
Set the appliance switch to "0".
Î Pull out the mains plug.
Î Lock the rear wheels.
Î Drain off and disose the remaining deter-
gent fluid.
Î Drain out the dirt water and dispose it off.
ṇ
Warning
Risk of damage! Do not wash down the ap-
pliance with water and do not use aggres-
sive detergents.
Î
Clean the outside of the appliance with a
damp cloth which has been soaked in
mild detergent.
Î Wipe the insides of the dirt water reser-
voir.
Î Clean the fluff filter.
The escalator cleaner must be accessible
from the bottom side to perform any testing
or maintenance jobs on the machine.
Î Take the help of another person to tilt the
machine forward until it stands on the
front casing.
Î Check spray pattern of the nozzles.
Î Check if suction nozzles are dirty.
Shutting down
Complete cleaning
Turn off device
Maintenance and care
Cleaning the device
Maintenance intervals
Tilt the machine in the maintenance po-
sition.
Daily before use