Karcher NT 65-2 Tact - Manual (Page 14)

– 3
– If wet dirt is vacuumed with the uphol-
stery or crevice nozzle, or if water is
sucked up from a container, it is recom-
mended to deactivate the "automatic fil-
ter cleaning" function.
– If the maximum liquid level is reached
the appliance will turn off automatically.
– In case of non-conductive liquids
(such as emulsion drilling fluids,
oils, and greases) the appliance is
not turned off when the container is
full. The filling level must be continu-
ously monitored and the container
must be emptied in time.
– After the wet vacuuming: Clean the flat
folded filter with the filter cleaning.
Clean the electrodes with a brush.
Clean the container with a damp rag
and dry it.
Illustration
The suction hose is equipped with a clip
system. All C-40/C-DN-40 accessories can
be connected.
 Plug in the main plug.
 Switch on the appliance at the rotating
knob.
The appliance has an innovative dual filter
cleaning system that is particularly effective
with fine dust. The flat pleated filter is auto-
matically cleaned every 7.5 seconds
through an air jet (pulsating sound).
 Switch off the appliance at the rotating
knob.
 Pull out the mains plug.
 Empty the container.
 Vacuum and wipe the appliance inside
and outside with a damp cloth.
 Loosen the fastening screws of the
pushing handle and adjust the pushing
handle.
Illustration

Store the suction hose and the mains
cable as shown in the illustration.
 Place the appliance in a dry room and
secure it from unauthorized use.
Caution
Risk of injury and damage! Observe the
weight of the appliance when you transport it.

Remove the suction pipe with the floor
nozzle from the holder. Hold the appli-
ance at the handle and at the suction
pipe to transport it.
 Hold the appliance at the chassis han-
dle and at the pushing handle when you
want to transport it.
 Pull the device behind you at the carry-
ing handle for transporting it over longer
distances
 When transporting in vehicles, secure
the appliance according to the guide-
lines from slipping and tipping over.
General
Clip connection
Operation
Rotating knob
– Appliance ON
– Filter dedusting OFF
– Appliance OFF
– Appliance ON
– Filter dedusting ON
Turning on the Appliance
Automatic filter cleaning
Turn off the appliance
After each operation
Fold the push handle in/out
Storing the Appliance
Transport
14 EN