Karcher NT 65-2 Tact - Manual (Page 13)

– 2
1 Electrodes
2 Suction hose
3 Pushing handle, adjustable
4 Suction head lock
5 Wheel
6 Dirt receptacle
7 Suction head
8 Steering roller
9 Chassis
10 Suction support
11 Chassis handle
12 Floor nozzle
13 Suction tube
14 Carrying handle
15 Hose and cable hook
16 Filter cover
17 Bender
18 Rotating knob
19 Storage for floor nozzle
20 Tilt lever
21 Nameplate
22 Drain hose
23 Holder for suction pipes
24 Power cord
25 Fastening screw for slider
26 Flat fold filter
27 Filter dedusting
– The operating elements for the cleaning
process are yellow.
– The controls for the maintenance and
service are light gray.
Caution
The flat pleated filter must always be in
place while vacuuming.
– To vacuum fine dust, you can also use
an additional paper filter bag, a fleece
filter bag (option) or a membrane filter
(option).
Illustration

Release and remove the suction head.
 Insert the paper filter bag, fleece filter
bag (option) or membrane filter (option).
 Insert and lock the suction head.
Illustration

Remove the brush strips.
 Install the rubber lips.
Note: The structured side of the rubber lips
must point outwards.
– If the appliance is used to vacuum wet
dirt, the paper filter bag, the fleece filter
bag (option) or the membrane filter (op-
tion) must always be removed.
– It is recommended to use a special filter
bag (wet) (see Filter systems).
Caution
Please observe the local provisions regard-
ing the wastewater treatment.
Appliance with metal container:
Illustration
Appliance with plastic container:
Illustration

Drain off dirty water through the drain-
age hose.
Device elements
Colour coding
Start up
Dry vacuum cleaning
Installing the paper filter bag/fleece filter bag
Wet vacuum cleaning
Inserting the rubber lips
Remove the paper filter bag/fleece filter bag
Drain off dirt water
13 EN