Karcher NT 611 Eco K - Manual (Page 16)

– 3
Illustration

Remove the locking cap (GEKA-C cou-
pling).
 Connect the disposal hose (nominal
width 3/4" or larger).
Illustration

Drain off dirty water through the drain-
age hose.
Caution
The coarse dirt filter must never be re-
moved during vacuuming.
– Wet vacuuming without disposal pump:
It is recommended to use a special filter
bag (wet) (see Filter systems).
– If the maximum liquid level is reached
the appliance will turn off automatically.
– After the wet vacuuming: Clean the
floater, container and the disposal
pump if necessary, using a damp rag
and dry them.
Caution
Prior to dry vacuuming: Remove the dis-
posal pump and install the flat fold filter.
Note: You must use a flat fold filter during
dry vacuuming.
Caution
The flat pleated filter must always be in
place while vacuuming.
– To vacuum fine dust, you can also use
an additional paper filter bag, a fleece
filter bag or a membrane filter.
 Unplug the mains plug of the disposal
pump.
 Release and remove the suction head.
Illustration

Unscrew the acorn nut of the disposal
pump.
 Remove the cable holder of the disposal
pump and replace it with a locking cap.
 Remove the disposal pump and the
plastic insert from the container.
Illustration

Install the locking cap instead of the dis-
posal hose.
 Insert and lock the suction head.
Note: The flat fold filter is not included in
the delivery.

Open filter door.
 Take out the coarse dirt filter.
 Install the flat fold filter.
 Close the filter door, it must lock into
place.
Illustration

Remove the rubber lips.
 Install the brush strip.
Note: A paper filter bag or a fleece filter bag
is not included in the delivery.
Illustration

Release and remove the suction head.
 Place the paper or fleece filter bag.
 Insert and lock the suction head.
Note: A membrane filter is not included in
the delivery.
Note: If you work without the paper filter
bag or fleece filter bag, you must use a
membrane filter to protect the suction head.
Illustration

Release and remove the suction head.
 Pull the membrane filter over the con-
tainer edge.
 Insert and lock the suction head.
Illustration
The suction hose is equipped with a clip
system. All C-40/C-DN-40 accessories can
be connected.
Connection of disposal pump
Drain off dirt water
General
Dry vacuum cleaning
General
Removal of the disposal pump
Installation of flat fold filter
Install the brush strip
Installing the paper filter bag/fleece filter
bag
Install membrane filter
Clip connection
16 EN