Karcher BD 40-12 C Bp Pack - Manual (Page 22)

– 7
 Press the switch of the suction turbine;
the vacuum process will start.
 Lower the vacuum bar.
 Push the appliance forward a bit.
 Switch off suction turbine switch.
 Adjustment of the vacuum bar, adjust if
necessary.
 Loosen the nut.
 Move the wheel upwards or down-
wards.
 Tighten nut.
 Check the setting of the vacuum bar.
 Tilt the appliance rearward.
 Use both hands to pull the disc brush to
the cleaning head.
 Turn the disk brush by approx. 45° in
anti-clock-wise direction (viewed from
above).
 Remove the disk brush at the bottom.
 Insert new disk brush in reverse se-
quence.
1 Filter inlay
2 Filter pot
 Unscrew the filter cup.
 Take out the filter inlay.
 Rinse the filter inlay with clear water.
 Install a new filter inlay.
 Install and tighten filter pot.
1 Suction hose
2 Screw
3 Main fuse, 30 A, green
 Loosen screws.
 Remove cover.
 Test the fuses, if necessary replace
with new fuses of the same capacity.
Check the vacuum bar setting
Setting the Vacuum Bar
Replacing the disk brushes
Clean the fresh water filter
Replacing fuses
22 EN