Haltech Platinum PRO PLUG-IN Nissan Silvia S15 / 200SX (HT055012) User Manual
Page 7
Rear Auxiliary Connector
The Platinum Pro Plugin Series allows further expansion of your ECU by the
Rear Auxiliary Connector.
The Rear Auxiliary connector allows you access to:
•
2 Additional Digital Pulsed Outputs ( DPO )
•
2 Additional Digital Switched Outputs ( DSO )
•
2 Additional Analogue Voltage Inputs ( AVI )
•
2 Additional Analogue Temperature Inputs ( ATI )
These extra Inputs / Outputs can be used to:
•
Fit additional sensors. (eg MAP and Temperature)
•
Control additional devices via relays
•
Control additional solenoids directly (eg Aftermarket Boost Control solenoid)
The Rear Auxiliary harness is available as an optional extra. ( HT040003 )
Figure 8 - Rear Auxiliary Harness Connector and Pinout
6.
With the Haltech ECU installed do not attempt to start the vehicle. You will need to
configure the ECU. The Haltech ECU is pre-configured for use with a SR20DET
standard engine. If this is your setup then you will not have to modify the basemap.
If your engine is not standard please adjust the configuration settings affected
according to your setup. With suitable settings and basemap loaded, your engine can
now be started.
Figure 6 – Haltech ECU Manager Software tuning page
7. With the engine started and running its now time to tune.
This is best achieved by your nearest engine tuner.
See the listing of Haltech dealers on our website to find the closest one to you.
www.haltech.com
1
2
3
4
9
10
11
12
5
6
7
8
13
14
15
16
Looking into Back Of Connector
Pin #
Wire Colour
Connection
1
O
+5V
2
Y
AVI1 (MAP)
3
O/B
AVI2
4
B/W
SIGNAL GROUND
5
V/B
DPO1
6
V/BR
DPO2
7
-
-
8
-
-
9
O
+5V
10
GY
ATI1 (AIR)
11
GY/B
ATI2
12
B/W
SIGNAL GROUND
13
V/R
DSO1
14
V/O
DSO2
15
-
-
16
-
-