Haltech Platinum PRO PLUG-IN SUBARU MY 01-05 (HT055174) User Manual
Page 10
Rear Auxiliary Connector
The Platinum Pro Plugin Series allows further expansion of your ECU by the
Rear Auxiliary Connector.
The Rear Auxiliary connector allows you access to:
•
1 Additional Digital Pulsed Input ( DPI )
•
2 Additional Digital Pulsed Outputs ( DPO )
•
2 Additional Digital Switched Outputs ( DSO )
•
4 Additional Analogue Voltage Inputs ( AVI )
•
2 Additional +13.8V Sensor Power Outputs (Limited to 500mA Per output pin)
•
2 Additional +5V Sensor Power Output (Limited to 50mA Per output pin)
•
Additional Sensor Power and Signal Grounds
These extra Inputs / Outputs can be used to:
•
Fit additional sensors. (eg MAP,Temperature and Flex Fuel )
•
Control additional devices via relays
•
Control additional solenoids directly (eg Aftermarket Boost Control solenoid)
The Rear Auxiliary harness is available as an optional extra. ( HT040003 )
Figure 8 - Rear Auxiliary Harness Connector and Pinout
6.
With the Haltech ECU installed do not attempt to start the vehicle. You will need to
configure the ECU. The Haltech ECU is pre-configured for use with a EJ20 standard
engine. If this is your setup then you will not have to modify the basemap.
If your engine is not standard please adjust the configuration settings affected
according to your setup. With suitable settings and basemap loaded, your engine can
now be started.
Figure 7 – Haltech ECU Manager Software tuning page
7. With the engine started and running its now time to tune.
This is best achieved by your nearest engine tuner.
See the listing of Haltech dealers on our website to find the closest one to you.
www.haltech.com
1
2
3
4
9
10
11
12
5
6
7
8
13
14
15
16
Looking into Back Of Connector
Pin #
Wire Colour
Connection
1
O
+5V (50mA Max)
2
Y
AVI1 (MAP)
3
O/B
AVI2
4
B/W
SIGNAL GROUND
5
V/B
DPO1
6
V/BR
DPO2
7
GY
DPI1
8
R
+13.8V (500mA Max)
9
O
+5V (50mA Max)
10
GY
AVI 3
11
GY/B
AVI 4
12
B/W
SIGNAL GROUND
13
V/R
DSO1
14
V/O
DSO2
15
-
-
16
R
+13.8V (500mA Max)