A.J. Antunes & Co VCT-2000 9210310 - Manual (Page 17)

17
VERTICAL CONTACT TOASTER
P/N 1010769 Rev. M 02/13
TROUBLESHOOTING (continued)
Problem Possible Cause Corrective Action
Crowns and/or Heels
must be forced into
the toaster. Buns
sticking and burning.
Belt Wraps not being cleaned
properly.
Clean Belt Wraps as described in the Maintenance
section of this manual.
Conveyor Belt Wraps are not tacky/
sticky (replace every 3–6 months).
Clean Belt Wraps. If the Belt Wraps are too worn,
replace them as described in the Maintenance
section of this manual.
Belt Wraps are dirty, worn, or dam-
aged (replace every 3–6 months).
Clean or replace Belt Wraps as described in the
Maintenance section of this manual.
Release Sheet is not being cleaned
properly.
Clean both sides of the black and silver Release
Sheet as described in the Maintenance section of
this manual.
Release Sheet is not being reversed
as required.
Reverse the Release Sheet or replace Release
Sheet as described in the Maintenance section of
this manual.
Release Sheet is dirty, worn, or
damaged (replace every 4–6 weeks).
Clean or replace Release Sheet as described in the
Maintenance section of this manual.
Conveyor Belt Chains are skipping
on Sprockets.
Measure and adjust the Conveyor Belt Chains as
described in the Maintenance section of this
manual.
Conveyor Safety Interlock Switch
is not being activated by the Heat
Shield.
Heat Shield is ajar. Reposition Heat Shield.
Heat Shield is damaged. Replace if necessary. If
the Conveyor Safety Interlock Switch is damaged,
contact your maintenance person or Authorized
Service Agency for service.
Belt Wraps slipping over Conveyor
Belt Chains.
Remove Belt Wraps and clean the Conveyor Belt
Chain links and Belt Wraps as described in the
Maintenance section of this manual.
Roller Tensioner(s) damaged or
missing.
Reinstall or replace Roller Tensioner(s) as described
in the Maintenance section of this manual.
Drive Motor stalls intermittently. Contact your maintenance person or an Authorized
Service Agency for service.
Compression Settings are incorrect. Use the recommended settings. Set Heel to 2 and
Crown to 6.
Buns are not inserted into the
toaster properly.
Buns must be inserted with the cut sides facing
each other on the correct Heel or Crown side.
Non OEM or damaged Belt Wraps
used.
Use only OEM Belt Wraps (P/N 7000416).
New Conveyor Belt
Wraps do not fit.
Compression Settings are incorrect. Set Compression Knobs to 6 and 6 when replac-
ing Belt Wraps or when adjusting Conveyor Belt
Chains.
Belt Wraps not installed correctly. Install Belt Wraps inside the Support Rods with the
zipper flap exposed and hanging down.
Non OEM or damaged Belt Wraps
used.
Use only OEM Belt Wraps (P/N 7000416).