A.J. Antunes & Co VCT-2000 9210310 - Manual (Page 14)

VERTICAL CONTACT TOASTER
14
P/N 1010769 Rev. M 02/13
MAINTENANCE (continued)
Checking the Roller Tensioners
(every 3–6 months)
MEASURING THE ROLLER TENSIONERS
1. Measure the Roller Tensioner on both inner
Conveyor Covers (Figure 11) using a U.S Nickel.
2. The space between the inner Conveyor Cover
and bottom of the Tensioner wheel should be
13/16” (2.1 cm) or the height of a U.S. Nickel.
3. Adjust or replace any damaged ones as
recommended.
REPLACING THE ROLLER TENSIONERS
1. Remove the acorn nuts and old Roller Tensioner
Assembly (Figure 12).
2. Replace Tensioner Assembly, and reassemble.
3. Make sure the spacers are placed inside the
Tensioner arm. The spacers are smaller than the
holes to allow the Tensioner to pivot freely.
Weld
Screws
Acorn Nuts
Spacers
Tensioner
Assy.
Tape
Figure 12. Replacing the Roller Tensioner
Figure 11. Measuring Roller Tensioner