ROTHENBERGER ROCLEAN Injektor - Manual (Page 12)

10 ENGLISH
– Open system / heating return flow.
– Open water supply.
– Press program key „water and air (permanently)“.
– The chemistry in the bottle is supplied to the fluid flow through. The Process is completed
when the bottle is empty.
No need to change bottles
– Press program key „water and air (permanently“ button). The compressed air supply is
stopped.
9. Close the return / supply points. Close the water supply and remove ROPULS. The preser-
vative remains in the system.
2.2 Cleaning (C)
After completion of dosing the ROCLEAN Injector must be flushed thoroughly with clean water
(safety function). Especially paying attention to the cleaning of the tube (see picture).
To clean the hose (the ROPULS is no longer attached to the cleaning system!) Give water to the
rinsed bottle. Set below the output of the injector (right side of ROPULS) an empty container (for
example a bucket). On the ROPULS ROCLEAN push the program button („Water unfair“ per-
manently) turn on and operate the fresh water supply. Catch the out coming water from the in-
jector with a container and dispose it in the drainage (Fig. C2).
Note: Always empty full bottles. Do not use it again!
Bottles are to be separated during transport from the injector!
2.3 Chemicals
Disinfection of drinking water pipes:
ROPULS disinfectant is a sterilization aid for drinking water based on hydrogen peroxide. It is
chlorine-free and odorless and suitable for all pipe materials. Safety note.
Note DVGW work sheet W 291
The sterilization aid is suitable for sterilization according to DVGW work sheet W291. If a sterili-
zation according to DVGW work sheet W291 will conducted to ensure that the relevant guide-
lines of the worksheet will be kept. If this means the ROCLEAN Injector is not possible, the steri-
lization done via the injection of ROPULS and external metering (see instructions ROPULS
Chapter 6.4). Safety note.
Cleaning of heating circuits with radiators
ROPULS radiator heating circuits cleaner is a neutral cleaner for the removal of chemical con-
taminants in typical heating circuits with radiators such as scaling and encrustations. It is suita-
ble for all pipe materials. ROPULS cleaners should not be longer than 24 hours in the system.
Safety note.
Cleaning of heating circuits with floor or space heaters
ROPULS cleaner floor heating circuits is a neutral cleaner for the removal of chemical contami-
nants in typical floor / surface heating as biofilms, bacteria and accumulation of mud. It is suita-
ble for all pipe materials. ROPULS cleaners should not be longer than 24 hours in the system.
Safety note.
Conservation of heating circuits (radiators and floor / space heaters)
ROPULS conservation medium is a tool to prevent corrosion, debris and noise in all types of
boiler hot water heating systems. It is suitable will used for all pipe materials and can be used
both in hard and soft water. The mixture is colorless and non-toxic and is discarded when emp-
tied of heating with heating water into the public sewer. Not suitable for drinking water pipes.
Safety note.